The Uwell Caliburn Pod Cartridge utilizes a horizontal coil configuration and rated at 1.4 ohm and 1.2ohm. This ensures that with each use you will get the purest flavor without the fear of burning out your coils.
The Caliburn Pod has a top fill system and can accommodate 2ml of your e-liquid.The UWELL CALIBURN replacement Pods (4-Pack) are a set of food-grade plastic pods featuring a 2.0mL refillable pod, 1.4ohm Pod Coil Resistance, and possesses a top fill system, stoppered by the top cap drip tip mouthpiece.
Uwell CALIBURN Replacement Pods Features:
- 2mL Capacity Juice Pods
- Pod Coil Resistance: 1.4ohm
- Food Grade Plastic Pod Construction
- Dual Port Top Fill System – Top Cap Drip Tip
- Comes in a pack of Four (4)
Uwell Caliburn Replacement pod Review
Caliburn pods hold up to 2ml of ejuice. You get two identical pods in the box which have built-in 1.4ohm coils. These pods are replaceable which means that you can’t change the coils. Once the pods are used/burned out you have to replace the entire pod. This is convenient for those who just want a simple device that they can fill and start using.
You can also use Caliburn Koko pods with the Caliburn. Those pods are 1.2ohm and have a red base (the base on the standard Caliburn pod is black).
Airflow is fed into the pod through small airflow holes on the sides of the Caliburn. This airflow then goes in through a hole on the bottom of the pod.
The mouthpiece on the pod slopes in on both sides and is comfortable to vape on. The mouthpiece on the pod also functions as the fill cap. You have to pull the cap off in order to access the fill ports but it’s difficult to get the cap off. Wiggling to cap side to side helps but it’s generally difficult to remove.
Uwell Caliburn Pod Cartridge Performance
Once you get the cap off you’ll see three holes. The middle hole is not a fill hole so don’t put ejuice in here or you’ll flood the coil! You can fill the pod using either of the outer holes. When you fill through one hole, the other hole allows air to escape to make filling it easier.
Even with the air release hole, you have to fill the pods slowly. Because the coil is in the middle of the pod, ejuice doesn’t distribute evenly unless you tilt the pod. Tilting the pod will get the ejuice to go to the opposite side. If you fill too fast, ejuice will fill up just the side of the hole you’re using and then come out the hole. When you’re done filling the mouthpiece/cap pressure fits back onto the pod.