Vaporesso Xros Nano Pod System Kit is powered by built-in 1000mAh battery to support whole day vaping. Xros Nano Pod Kit features AXON Chip with Pulse Mode to deliver great flavors and ensure the ultimate MTL vaping. Vaporesso Xros Nano Cartridge has 2ml capacity with SSS leak-resistant technology. Xros Nano Pod is available for both clockwise and counterclockwise ways to replace the coil, easier to adjust your coil. The anti-skid design makes sure your coil is firm once it is installed. The clamshell top filling system also eliminates the trouble of removing your pod cartridge out of your kit and a messy hand. Vaporesso Xros Nano is compatible with other XROS series pods.
Vaporesso Xros Nano Parameters:
- Size: 14.9* 48.8* 63.1mm
- Battery: 1000mAh built-in battery
- Charging: Type-C, 1A
- Capacity: 2ml
- Resistance: 0.8ohm/1.2ohm
- 1* Vaporesso XROS Nano Battery
- 1* Vaporesso XROS series 0.8ohm Mesh Pod
- 1* Vaporesso XROS series 1.2ohm Pod
- 1* Type-C USB Cable
- 1* Lanyard
- 1* User Manual
Vaporesso Xros Nano Battery & Charging
Like the XROS 2 and XROS Mini, the XROS Nano has a 1000mAh battery. Also like the XROS 2, the battery life indicator consists of 4 LEDs which are stacked vertically. Whenever you take a draw, the LED’s light up to indicate your charge level:
- 4 LEDs: above 80% battery
- 3 LEDs: 80-60% battery
- 2 LEDs: 60-30% battery
- 1 LED: below 30% battery
Battery life is good on the XROS Nano and similar to the XROS 2. You can vape around 2 pods of ejuice per charge, so somewhere around a day or two depending on how much you vape. If you don’t vape very much then I could see a charge lasting even longer.
The XROS Nano recharges very quickly thanks to its use of Type-C charging. The port is located on the bottom of the device so you have to lay it on it’s side to charge. It takes approximately 45-55 minutes to recharge from a completely dead battery, however it does have pass-thru charging so you can vape on it while it charges.